Sodium Thiosulfate
Sodium Thiosulfate is an FDA drug label for the active ingredient SODIUM THIOSULFATE manufactured by Hope Pharmaceuticals administered by INTRAVENOUS. This page reproduces the FDA-approved indications and usage, dosage, contraindications, warnings, and adverse reactions exactly as published in the drug label. Data source: openFDA (U.S. FDA), label effective 20260526.
- Generic name
- SODIUM THIOSULFATE
- Manufacturer
- Hope Pharmaceuticals
- Product type
- HUMAN PRESCRIPTION DRUG
- Route
- INTRAVENOUS
- Dosage form
- N/A
- NDC
- 60267-705
- Application
- NDA203923
- Label effective
- 20260526
About this product
Sodium Thiosulfate is an FDA-registered drug product whose active ingredient is SODIUM THIOSULFATE. It is labelled by Hope Pharmaceuticals taken by intravenous and marketed as a human prescription drug product. Identifiers on file: NDC 60267-705, application NDA203923, label effective 20260526. This page reproduces the FDA-approved label text so you can check what a product is, who makes it and how it is supplied before discussing it with a pharmacist or prescriber.
What it is used for
Across FDA labelling, products containing SODIUM THIOSULFATE are most often described in connection with: cyanide poisoning, sodium thiosulfate, treatment acute, judged serious, injection indicated, potential risks, carefully weighed, benefits especially. Wording differs between labels, and the full indications section on this page takes precedence when it is present.
Indications & Usage
1 INDICATIONS AND USAGE Sodium Thiosulfate Injection is indicated for sequential use with sodium nitrite for the treatment of acute cyanide poisoning that is judged to be serious or life-threatening. When the diagnosis of cyanide poisoning is uncertain, the potential risks associated with Sodium Thiosulfate Injection should be carefully weighed against the potential benefits, especially if the patient is not in extremis. Sodium Thiosulfate Injection, an antidote, is indicated for sequential use with sodium nitrite for treatment of acute cyanide poisoning that is judged to be serious or life-threatening. ( 1 ) Use with caution if the diagnosis of cyanide poisoning is uncertain. ( 1 )
Dosage & Administration
2. DOSAGE AND ADMINISTRATION If clinical suspicion of cyanide poisoning is high, administer Sodium Thiosulfate Injection without delay and in conjunction with appropriate airway, ventilatory, and circulatory support. ( 2.1 ) The expert advice of a regional poison control center may be obtained by calling 1-800-222-1222. ( 2.1 ) Dosing : Age Intravenous Dose of Sodium Nitrite and Sodium Thiosulfate Adults 1.) Sodium Nitrite -10 mL of sodium nitrite at the rate of 2.5 to 5 mL/minute 2.) Sodium Thiosulfate - 50 mL of sodium thiosulfate immediately following administration of sodium nitrite. Children 1.) Sodium Nitrite - 0.2 mL/kg (6 mg/kg or 6-8 mL/m 2 BSA) of sodium nitrite at the rate of 2.5 to 5 mL/minute not to exceed 10 mL 2.) Sodium Thiosulfate - 1 mL/kg of body weight (250 mg/kg or approximately 30-40 mL/m 2 of BSA) not to exceed 50 mL total dose immediately following administration of sodium nitrite. Redosing : If signs of cyanide poisoning reappear, repeat treatment using one-half the original dose of both sodium nitrite and sodium thiosulfate. ( 2.2 ) Monitoring : Blood pressure must be monitored during treatment. ( 2.2 ) Sodium thiosulfate is chemically incompatible with hydroxocobalamin and should not be administered via the same intravenous line. (2.4) 2.1 Important Dosage and Administration Instructions If clinical suspicion of cyanide poisoning is high, administer Sodium Thiosulfate Injection without delay. Comprehensive treatment of acute cyanide intoxication requires support of vital functions. Administration of sodium nitrite and sodium thiosulfate should be considered adjunctive to appropriate supportive therapies. Airway, ventilatory and circulatory support, and oxygen administration should not be delayed in order to administer sodium nitrite and sodium thiosulfate [see Warnings and Precautions (5.1) ] . The expert advice of a regional poison control center may be obtained by calling 1-800-222-1222. Identifying Patients with Cyanide Poisoning Cyanide poisoning may result from inhalation, ingestion, or dermal exposure to various cyanide-containing compounds, including smoke from closed-space fires. Sources of cyanide poisoning include hydrogen cyanide and its salts, cyanogenic plants, aliphatic nitriles, and prolonged exposure to sodium nitroprusside. The presence and extent of cyanide poisoning are often initially unknown. There is no widely available, rapid, confirmatory cyanide blood test. Treatment decisions must be made on the basis of clinical history and signs and symptoms of cyanide intoxication. Table 1. Common Signs and Symptoms of Cyanide Poisoning Symptoms Signs Headache Confusion Dyspnea Chest Tightness Nausea Altered Mental Status (e.g., confusion, disorientation) Seizures or Coma Mydriasis Tachypnea/Hyperpnea (early) Bradypnea/Apnea (late) Hypertension (early)/ Hypotension (late) Cardiovascular Collapse Vomiting Plasma Lactate Concentration ≥ 8 mmol/L In some settings, panic symptoms including tachypnea and vomiting may mimic early cyanide poisoning signs. The presence of altered mental status (e.g., confusion and disorientation) and/or mydriasis is suggestive of true cyanide poisoning although these signs can occur with other toxic exposures as well. Smoke Inhalation Not all smoke inhalation victims will have cyanide poisoning and may present with burns, trauma, and exposure to other toxic substances making a diagnosis of cyanide poisoning particularly difficult. Prior to administration of Sodium Thiosulfate Injection, smoke-inhalation victims should be assessed for the following: Exposure to fire or smoke in an enclosed area Presence of soot around the mouth, nose, or oropharynx Altered mental status Although hypotension is highly suggestive of cyanide poisoning, it is only present in a small percentage of cyanide-poisoned smoke inhalation victims. Also indicative of cyanide poisoning is a plasma lactate concentration greater than or equal to 10 mmol/L (a value higher than that typically listed in the table of signs and symptoms of isolated cyanide poisoning because carbon monoxide associated with smoke inhalation also contributes to lactic acidemia). If cyanide poisoning is suspected, treatment should not be delayed in order to obtain a plasma lactate concentration. Use with Other Cyanide Antidotes The safety of administering other cyanide antidotes simultaneously with Sodium Thiosulfate Injection has not been established. If a decision is made to administer another cyanide antidote with Sodium Thiosulfate Injection, these drugs should not be administered concurrently in the same intravenous (IV) line. [see Dosage and Administration (2.2) ] 2.2 Recommended Dosing Sodium Nitrite Injection and Sodium Thiosulfate Injection are administered by slow intravenous injection. They should be given as early as possible after a diagnosis of acute life-threatening cyanide poisoning has been established. Sodium nitrite should be administered first, followed immediately by sodium thiosulfate. Blood pressure must be monitored during infusion in both adults and children. The rate of infusion should be decreased if significant hypotension is noted. Age Intravenous Dose of Sodium Nitrite and Sodium Thiosulfate Adults 1.) Sodium Nitrite -10 mL of sodium nitrite at the rate of 2.5 to 5 mL/minute 2.) Sodium Thiosulfate - 50 mL of sodium thiosulfate immediately following administration of sodium nitrite. Children 1.) Sodium Nitrite - 0.2 mL/kg (6 mg/kg or 6-8 mL/m 2 BSA) of sodium nitrite at the rate of 2.5 to 5 mL/minute not to exceed 10 mL 2.) Sodium Thiosulfate - 1 mL/kg of body weight (250 mg/kg or approximately 30-40 mL/m 2 of BSA) not to exceed 50 mL total dose immediately following administration of sodium nitrite. NOTE: If signs of poisoning reappear, repeat treatment using one-half the original dose of both sodium nitrite and sodium thiosulfate. In adult and pediatric patients with known anemia, it is recommended that the dosage of sodium nitrite should be reduced proportionately to the hemoglobin concentration. Visually inspect all parenteral drug products for particulate matter and discoloration prior to administration. 2.3 Recommended Monitoring Patients should be monitored for at least 24-48 hours after Sodium Thiosulfate Injection administration for adequacy of oxygenation and perfusion and for recurrent signs and symptoms of cyanide toxicity. When possible, obtain hemoglobin/hematocrit when treatment is initiated. Measurements of oxygen saturation using standard pulse oximetry and calculated oxygen saturation values based on measured PO 2 are unreliable in the presence of methemoglobinemia. 2.4 Incompatibility Information Chemical incompatibility has been reported between Sodium Thiosulfate Injection and hydroxocobalamin and these drugs should not be administered simultaneously through the same IV line. No chemical incompatibility has been reported between sodium thiosulfate and sodium nitrite, when administered sequentially through the same IV line as described in Dosage and Administration. Simultaneous administration of Sodium Thiosulfate Injection and blood products (whole blood, packed red cells, platelet concentrate and/or fresh frozen plasma) through the same intravenous line is not recommended. However, blood products and Sodium Thiosulfate Injection can be administered simultaneously using separate intravenous lines (preferably on contralateral extremities, if peripheral lines are being used).
Contraindications
4 CONTRAINDICATIONS None None. ( 4 )
Adverse Reactions
6 ADVERSE REACTIONS There have been no controlled clinical trials conducted to systematically assess the adverse events profile of sodium thiosulfate. The medical literature has reported the following adverse events in association with sodium thiosulfate administration. These adverse events were not reported in the context of controlled trials or with consistent monitoring and reporting methodologies for adverse events. Therefore, frequency of occurrence of these adverse events cannot be assessed. Cardiovascular system: hypotension Central nervous system: headache, disorientation Gastrointestinal system: nausea, vomiting Hematological : prolonged bleeding time Body as a Whole: salty taste in mouth, warm sensation over body In humans, rapid administration of concentrated solutions or solutions not freshly prepared, and administration of large doses of sodium thiosulfate have been associated with a higher incidence of nausea and vomiting. However, administration of 0.1 g sodium thiosulfate per pound up to a maximum of 15 g in a 10-15% solution over 10-15 minutes was associated with nausea and vomiting in 7 of 26 patients without concomitant cyanide intoxication. In a series of 11 human subjects, a single intravenous infusion of 50 mL of 50% sodium thiosulfate was associated with increases in clotting time 1-3 days after administration. However, no significant changes were observed in other hematological parameters. Most common adverse reactions are: Hypotension, headache, disorientation ( 6 ) To report SUSPECTED ADVERSE REACTIONS, contact Hope Pharmaceuticals at 1-800-755-9595 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch .
Recall and safety notices
3 FDA recall record(s) match this product name or manufacturer. A match means the firm or product name appears in the enforcement report; confirm lot numbers and dates against the official FDA notice before acting.
| Recall | Product | Firm | Class | Status | Reported |
|---|---|---|---|---|---|
| D-446-2014 | Sodium Thiosulfate PF, 10 % injectable, Rx only, Specialty Medicine Compounding Pharmacy, 350 S Lafayette, South Lyon, MI 48178 | Specialty Medicine Compounding Pharmacy | Class II | Terminated | 20140122 |
| D-273-2014 | Sodium Thiosulfate 25% 50ml, Main Street Compounding Pharmacy, 126 East Main Street, Newbern, TN 38059, 888-658-6200 | Main Street Family Pharmacy, LLC | Class II | Terminated | 20131211 |
| D-1044-2013 | Sodium Thiosulfate 25%, 250 mg/mL (12.5 g/50mL), PF Sterile Solution for Injection, 50 mL Single Dose Vial, For Office Use Only, JCB Laboratories, Wichita, KS. | JCB Labs LLC | Class II | Terminated | 20130925 |
Frequently asked questions
What is Sodium Thiosulfate used for?
1 INDICATIONS AND USAGE Sodium Thiosulfate Injection is indicated for sequential use with sodium nitrite for the treatment of acute cyanide poisoning that is judged to be serious or life-threatening. When the diagnosis of cyanide poisoning is uncertain, the potential risks associated with Sodium Thiosulfate Injection should be carefully weighed against the potential benefits, especially if the …
Who makes Sodium Thiosulfate?
Hope Pharmaceuticals is the labeler of record for Sodium Thiosulfate.
What form does Sodium Thiosulfate come in?
administered by intravenous. Strengths and pack sizes vary by label, so compare the NDC on your pack with the identifier listed on this page.
Is Sodium Thiosulfate prescription or over-the-counter?
The FDA label for this product is recorded as human prescription drug. Marketing status can differ between strengths and countries, so check the dispensing rules where you live.
Has Sodium Thiosulfate been recalled?
3 FDA recall record(s) match this product name or manufacturer. Review the recall and safety notices section on this page and confirm lot numbers against the official FDA enforcement report.
Where does this information come from?
All content is reproduced from FDA Structured Product Labelling data via openFDA. It is provided for identification and reference only and is not medical advice.
This page reproduces FDA Structured Product Labelling data for identification and reference. It is not medical advice, does not diagnose or treat any condition, and does not sell or price any medicine.